I used a basic switch from fritzing panel. How do i move the wemos finely so its pins DO NOT go into the battery holder in bottom layer.

It seems to “SNAP” into locations, and hence, the pins interfere with battery. The challenge i have here is, i am not able to move the Wemos “finely”. I know this is possible because i have a prototype that i made exactly like this, and it works.(see pics) However, note that the Wemos (top layer) PINs need to clear the holder. I want the bat holder to be in bottom layer of PCB, so that my overall WidthXHeight of PCB is small. I am not sure if i have placed the 4.7KOHM resistor correctly in the circuit diagram. Basic Design is as per this circuit diagram.Ī) I connected the Power Pin to 5V on Wemos from Battery.There are a few areas that i am not sure of, so i would greatly appreciate if you can validate them. The battery i am using is 18650 li-ion style. I am trying to make a simple temp sensor board connected to Wemos D1 Mini and have sleep mode on it. I am designing my second board, and as always appreciate if you can review the design. Thanks for any help, I am super new to this so any help is greatly appreciated!! Should I leave the Motor and Logic GND traces separated on the bottom layer and not add the Ground Fill? If I do not add the Ground Fill do I place Ground Seeds…? If I do this way should I remove the GND traces? My question is, should I leave it like I have and just have the “Ground Seeds and Ground Fill” on the bottom layer, which would make the traces unnecessary, but would also leave the Motor and Logic GND the same (I think). I have all the traces for the Motor GND and the Logic GND separated… I put all the traces for the Grounds on the bottom layer of the PCB and then I saw that you should add “Ground Fill Seeds” and add a “Ground Fill Layer”, I did that and then when I got the PCB back there were no visible Ground traces on the bottom, but I guess that is to be expected because of the Ground fill, I guess. I want to make sure I have the Ground correct, but I’m very confused with the Ground and I keep seeing all kinds of different things. Hello, I just ordered a PCB and it came back but I messed up on a couple of things.

20x4 lcd library fritzing part